Garage Door Sensor Repair

Garage Door Sensor Repair in Franklin, WI

If your garage door will not close, reverses as soon as it starts down, or the opener lights blink, the photo-eye safety sensors are the usual cause. They are a small part with a big job — and they can usually be fixed without replacing your opener.

Signs Your Garage Door Sensors Need Repair

Sensor trouble is easy to spot once you know the signs. Call us if you notice any of these:

  • Door starts to close, then reverses immediately
  • Door will not close at all, but opens normally
  • Opener lights blink or flash when you try to close it
  • One sensor light is out, flickering, or a different color
  • Door closes only if you hold the wall button down

These symptoms can also come from the opener itself. For opener problems that are not sensor-related, see garage door opener repair.

First, try these safe checks

Clean both sensor lenses with a soft, dry cloth, clear away anything blocking the beam, and check that both sensors point at each other. If the lights stay steady and the door works, you may have fixed it.

What Causes Sensor Problems?

Sensors sit low on the door track, where they take a lot of knocks. These are the causes we see most often in Franklin:

Alignment, dirt, and sunlight

Sensors are easily bumped, splashed with salt and slush, or blinded by low winter sun. A knocked sensor, a dirty lens, or glare can break the beam.

Wiring and age

Wires can be chewed, pinched, or corroded, and old sensors can fail after years in a cold garage. We test the wiring and the sensors before replacing anything.

How Sensor Repair Works

Most sensor repairs follow the same careful order:

  1. Check the lights. We check both sensor indicator lights and the opener’s blink pattern, which tells us where the fault is.
  2. Align and clean. Sensors are realigned, cleaned, and secured, and the beam is tested across the full width of the door.
  3. Test the wiring. Wiring is checked for breaks and loose connections, and damaged wire is repaired or replaced.
  4. Replace if needed. If a sensor has failed, we fit a matched replacement pair, align them, and test the door through several cycles.

Never Bypass or Disconnect Sensors

Sensors stop the door from closing on a person, a pet, or a car. Disconnecting or taping over them removes that protection and can be dangerous. If your door will not close, call us instead of bypassing the sensors.

Wisconsin Weather and Sensors

Road salt, slush, and freezing temperatures are hard on low-mounted sensors. We fit them securely, check the wiring, and make sure the lenses stay clear through winter.

Frequently Asked Questions

Why does my door close only when I hold the button?

Holding the wall button overrides the sensors. It usually means the sensors are misaligned, dirty, or faulty — the door is telling you the safety system needs attention.

Why do the opener lights blink?

Blinking lights are the opener’s way of saying the sensors are not seeing each other. Check for a blockage, a dirty lens, or a bumped sensor first.

Can sunlight affect garage door sensors?

Yes. Low winter sun shining straight into a sensor can blind it. We can fit a small shade or move the sensor slightly to fix it.

How long does sensor repair take?

Most sensor repairs are a quick visit — alignment and cleaning take minutes, and a replacement pair is usually fitted and tested in under an hour.

How much does sensor repair cost?

It depends on whether the sensors need aligning, new wiring, or a replacement pair. We will give you a price before any work begins. See our garage door repair cost guide for the typical published ranges.

Other Garage Door Services

Garage Door Repair

Everyday repairs, from noisy rollers to doors that will not open.

Garage Door Opener Repair

Openers that hum, stop, or refuse to respond, diagnosed and repaired.

Garage Door Spring Repair

Broken or worn springs, replaced safely and matched to your door.

Garage Door Cable Repair

Frayed or loose cables, replaced before they snap or slip.

Emergency Garage Door Repair

Urgent problems, including doors that will not close or secure your home.

Serving Franklin, Greenfield, Oak Creek, New Berlin, Hales Corners, Greendale, Muskego, South Milwaukee, and Cudahy, Wisconsin.

Door Won’t Close? Let Us Fix the Sensors.

Serving Franklin, Greenfield, Oak Creek, New Berlin, Hales Corners, Greendale, Muskego, South Milwaukee & Cudahy.